Common Faults When Using Packing Belts

　　In the process of using packing belts, we will inevitably encounter some problems. Today, we will ask the straps factory to briefly answer three common questions.

　　1. The tightness is the key to measuring the effect of packing belts because whether it is too loose or too tight will affect the use of the product. Therefore, it is very important to master its tightness. To use it, let's understand its two-point tightness.

　　1. 5%-25% is the ideal range of use for packing belts. Depending on the particularity of the packaging material, different degrees of stretching is carried out, but the control of the degree of stretching must be mastered.

　　2. Too tight, that is, the stretch is greater than 25%. At this time, the elasticity of the packing belts will be damaged due to excessive stretching.

　　3. Too loose, that is, the stretch is less than 5%. At this time, due to the insufficient elongation of the packing belts, their elasticity has not been fully exerted, and the straps are relatively loose. looser and looser to create a slack situation.

　　2. Plastic steel packing belts are a more commonly used packing material. In addition to packaging some common products, some products that are difficult to package will also choose it for packaging. It's convenient to use, but it's also a bit cumbersome to use. Users, that is, packing belts sometimes curl up during use, what are the factors that cause this phenomenon?

　　Generally speaking, two main factors cause wrapping tape to curl. One is due to improper operation. During operation, the speeds of the three machines of the weft retractor, the governor, and the wire drawing machine must be synchronized, otherwise, the cable tie may be curled; to avoid kinking, the cable tie may be curled.

　　3. Packing belt slippage is an accidental phenomenon. It also has to do with correct operation. How do deal with this phenomenon?

　　1. Slippage may also be due to low friction, so friction will increase, such as marks.

　　2. Most slippage is caused by joint loosening. Therefore, the connector should be inspected before use.